Engine #1

Engine #3

Engine #5

Engine #6

Engine #7

Engine #8

Engine #9

Engine #10

Price and Order Info
 
 

Engine #10

Single Cylinder Column Marine Engine

• 2 1/4" Bore by 3 " Stroke
• Rated 2 hp at 400 RPM on 125 psi
• Stephensen Reverse Gear
• Feedwater Pump
• Height 18 Inches
• Weight with Flywheel 48-lbs.

• No castings required.
• All turning can be done on a 9 inch lathe.
• Ball and needle bearings are used on all rotating shafts.
• The finished engine must have the appearance and proportions of a True Marine Column Engine.

The Engine has a cylinder made from a cast iron block. The cylinder is lagged with wood held on with brass bands. Upper and Lower cylinder drains are provided with piping down to the engine base.

The crosshead bearing is a needle bearing and it is provided with an internal passage so that it can be lubricated using a small Grease Gun designed for lubricating the nose sprocket on chain saw blades. An oil box is provided with a hinged lid which houses the wick feed oiling to the crosshead guides.

The Feedwater pump-is driven from the crosshead and is a .250 inch Dia. Stainless Steel rod. The check valves are Stainless Steel Balls which are readily accessible and the lift can be controlled for quiet operation.

A large Crank-Disk is used to provide-a well balanced engine. Steam passages are direct and of adequate size.

The Reverse Lever is provided with four notches for linking up.

PLANS PACKAGE

Sheet 1 Has a full size Cut-away Assembly Drawing Showing every part

The 4 Additional Sheets Show Every detail part full size and completlely dimensioned. . They are high quality and represent many hours of design time

Instruction sheets are included for some details where machining sequence or hints might be helpful. Illustrations are also shown of several machining operations. A sharp color photo of the engine is also included.

The full set of Plans Engine # 10 is just $24.95